Call (909) 792-4776

Go to…

Honda

Home / Honda

We Service and Repair all Honda cars

  • 2018 Honda CR-V

    Honda CR-V
    Mileage
    22,891
    Service Date
    1/24/2025
    Services Performed
    • INSTALL MISSING LOWER ENGINE SHIELD
     
    CAROLINE M. gave our service a 5 star review on 1/24/2025

  • 2018 Honda CR-V

    Honda CR-V
    Mileage
    22,404
    Service Date
    10/15/2024
    Services Performed
    • SERVICE AIR CONDITIONER. CHECK CONDITION OF ALL BELTS AND LINES. EVACUATE AND RECHARGE WITH R-134. TEST SYSTEM PERFORMANCE.
     
    CAROLINE M. gave our service a 5 star review on 10/15/2024

  • 2012 Honda Odyssey

    Honda Odyssey
    Mileage
    97,878
    Service Date
    7/24/2024
    Services Performed
    • FOUND: tested the charging system. The alternator is not putting out voltage to charge the battery. The alternator has ignition power and ground and a complete circuit to the battery on the positive battery cable. Recommend replace the alternator and the serpentine belt and retest.
    • Alternator replaced and tested ,alternator tested good.
     
    TERRY S. gave our service a 5 star review on 7/24/2024

  • 2020 Honda Civic

    Honda Civic
    Mileage
    76,597
    Service Date
    11/4/2023
    Services Performed
    • FOUND:
    • Courtesy Vehicle Inspection: Includes vehicle inspection – report to be sent via text on any visual observations & any Scheduled MFG recommendations.
    • Install engine shield and hardware
    • STABILIZER BAR CONTROL LINK – Remove & Replace – Both
    • ROAD TEST VEHICLE. CHECK ALL SUSPENSION AND STEERING PARTS FOR WEAR. CHECK TIRE PRESSURE AND CONDITION. CHECK RIDING HEIGHT. CHECK ALIGNMENT OF ALL FOUR WHEELS. ADJUST CASTER, CAMBER, TOE-IN, AND THRUST ANGLE AS NEEDED ON ALL FOUR WHEELS. CENTER STEERING WHEEL..
    • Remove wheels from vehicle. Inspect brakes. Computer spin balance. Reinstall wheels to vehicle and torque lug nuts to manufacturer's specifications.
    • NSPECT ALL HYDRAULIC LINE AND HOSES. INSPECT CALIPERS AND WHEEL CYLINDERS. INSPECT MASTER CYLINDER AND CAP. FLUSH ENTIRE BRAKE SYSTEM INCLUDING MASTER CYLINDER, CALIPERS, WHEEL CYLINDERS UNTIL CLEAN.
    • FUEL INJECTION SERVICE
    • THROTTLE BODY CLEANING
    • CABIN AIR FILTER – Remove & Replace – [Includes: R&I Glove Box.]
    • REMOVE & REPLACE WIPER BLADES
     
    SCOTT M. gave our service a 5 star review on 11/4/2023

  • 2005 Honda Accord

    Honda Accord
    Mileage
    159,713
    Service Date
    7/29/2023
    Services Performed
    • FOUND: SCANNED FOR CODES, P1009 VTC SYSTEM STUCK IN THE ADVANCED POSITION, P2647 VTEC PRESSURE SWITCH CIRCUIT VOLTAGE HIGH, 61-1 BATTERY VOLTAGE LOW AND B1177 ABNORMAL BATTERY VOLTAGE. CHECKED ENGINE OIL LEVEL, LEVEL IS ABOUT 1QRT LOW. RECOMMEND ADDING 1 QRT ENGINE OIL AND REPLACING VVT OIL PRESSURE SENSOR. TESTED BATTERY ONLY AT 11.7V AND 48% LOAD. RECOMMEND REPLACING BATTERY.
    • VARIABLE VALVE TIMING OIL SENDER- Remove & Replace – In-Line4
    • CLEAN CNNECTIONS AND CABLES, TEST BATTERY AND CHARGING SYSTEM.
    • REMOVE AND REPLACE MOTOR OIL AND OIL FILTER, LUBE CHASSIS WHERE APPLICABLE, CHECK TIRE PRESSURE AND ALL FLUID LEVELS.
     
    ANNETTE G. gave our service a 5 star review on 7/29/2023

  • 2005 Honda Pilot

    Honda Pilot
    Mileage
    358,341
    Service Date
    1/19/2023
    Services Performed
    • FOUND: found codes P0171 & P0175 bank 1 & 2 system to rich, code P0 741 Torque converter circuit performance/ stuck off, code P0420 for catalyst system below threshold bank 1, code P0747 pressure control solenoid A stuck on, , code 2138 Accelerator Position Sensor switch D/E voltage correlation.
    • FOUND: left rear tire pressure sensor is not reading.
    • HOOD PROP IN BACK, WOULD LIKE FIXED. – INSTALL HOOD ROD GROMMET, AND HOOD ROD
    • FOUND: found the air filter really dirty, maybe the cause for P0171 and P00175, the other thing that can cause rich conditions is Valve adjustment, can try a new air filter first and maybe some spark plugs, also P2138 for acceleration Pedal Position Sensor should be replaced because of Glitches on the scan tool.
    • Courtesy Vehicle Inspection: Includes vehicle inspection – report to be sent via text on any visual observations & any Scheduled MFG recommendations.
    • Courtesy Vehicle Inspection: Includes vehicle inspection – report to be sent via text on any visual observations & any Scheduled MFG recommendations.
    • REMOVE AND REPLACE MOTOR OIL AND OIL FILTER, LUBE CHASSIS WHERE APPLICABLE, CHECK TIRE PRESSURE AND ALL FLUID LEVELS.
    • REMOVE & REPLACE LR TIRE PRESSURE SENSOR MONITOR
    • Remove & replace air filter
    • ACCELERATOR PEDAL POSITION SENSOR – Remove & Replace – Sensor
     
    CLAUDIA N. gave our service a 5 star review on 1/20/2023

  • 2008 Honda Accord

    Honda Accord
    Mileage
    177,550
    Service Date
    1/9/2023
    Services Performed
    • FOUND: there was a short in one of the LED lights that illuminate the license plate. Remove the LED bulbs and replace with conventional bulbs 168. The fuse is not blowing at this time.
     
    RYAN W. gave our service a 5 star review on 1/9/2023

  • 2020 Honda Pilot

    Honda Pilot
    Mileage
    75,464
    Service Date
    12/30/2022
    Services Performed
    • REMOVE AND REPLACE MOTOR OIL AND OIL FILTER, LUBE CHASSIS WHERE APPLICABLE, CHECK TIRE PRESSURE AND ALL FLUID LEVELS.
    • Courtesy Vehicle Inspection: Includes vehicle inspection – report to be sent via text on any visual observations & any Scheduled MFG recommendations.
    • TIRE ROTATION CAR
    • INCLUDES REPLACING BRAKE PADS, REPLACING OR RESURFACE ROTORS, CLEAN, ADJUST AND ROAD TEST.
     
    SEAN P. gave our service a 5 star review on 12/31/2022

  • 2008 Honda CR-V

    Honda CR-V
    Mileage
    103,673
    Service Date
    9/26/2022
    Services Performed
    • REMOVE & REPLACE CATALYTIC CONVERTER
    • OXYGEN SENSOR – Remove & Replace – Each
    • Pre Repair Scan
    • Post Repair Scan
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – BOTH
    • REMOVE & REPLACE EXHAUST PIPE
    • INSTALL AIR FUEL RATION SENSOR, OXYGEN SENSOR REAR
     
    TIDA T. gave our service a 5 star review on 9/27/2022

  • 2006 Honda Accord

    Honda Accord
    Mileage
    217,402
    Service Date
    8/10/2022
    Services Performed
    • SMOG INSPECTION
    • FOUND: there are three separate trouble codes stored: p0325 knock sensor circuit fault, p2138 throttle pedal position sensor correlation fault, and P0171 system lean. Additional diagnostic time will be needed due to the number of codes. 2.0 additional. The clamp that secures the intake air boot to the mass air flow sensor is missing the screw that tightens it. This may cause false air to get past the mass air flow sensor which could result in a lean condition. Also found that the mass air flow sensor appears to be incorrectly calculating the amount of air entering the engine at times. There is a temperature sensor that is part of the mass air flow sensor that measures air temperature. It also appears to be out of calibration at times reporting an air temperature of 40° It may be wise to repair the intake boot clamp and replace the mass air flow sensor and then reevaluate the knock sensor code. A lean condition could cause a spark knock which the computer May blame on a defective knock sensor. If the knock sensor code comes back it can be addressed at that time.
    • See notes under check engine light diagnosis.
    • Courtesy Vehicle Inspection: Includes vehicle inspection – report to be sent via text on any visual observations & any Scheduled MFG recommendations.
    • FOUND:
    • FOUND:
    • FOUND:
    • MASS AIR FLOW SENSOR – Remove & Replace
    • RUN OBDII MONITORS [3 OUTCOMES POSSIBLE] 1] PASS MONITORS 2] CHECK ENGINE LIGHT COMES BACK ON – DIAGNOSIS REQUIRED 3] MONITORS WILL NOT PASS – DIAGNOSIS REQUIRED
    • SMOG RE-INSPECTION
    • Remove & replace air filter
    • CLEAN CNNECTIONS AND CABLES, TEST BATTERY AND CHARGING SYSTEM.
    • KNOCK SENSOR – Remove & Replace – In-Line4 – [Includes: R&I Intake Manifold.]
    • FUEL INJECTION SERVICE
    • THROTTLE BODY CLEANING
    • STEERING GEAR (COMPLETE) – Remove & Install or Remove & Replace – [Includes: Adjust toe-in on Rack and Pinion type Steering Gears. NOTE: Deduct .4 if alignment is also performed.]
    • ROAD TEST FOR POWER STEERING OPERATION. INSPECT SYSTEM FOR LEAKS. FLUSH POWER STEERING LINES, PUMP, RACK AND PINION, AND OR GEAR BOX. INSTALL NEW POWER STEERING FLUID. INSTALL POWER STEERING ADDITIVE TO REVITALIZE SEALS. ROAD TEST.
    • POWER STEERING PUMP – Remove & Replace – In-Line4
    • ROAD TEST VEHICLE. CHECK ALL SUSPENSION AND STEERING PARTS FOR WEAR. CHECK TIRE PRESSURE AND CONDITION. CHECK RIDING HEIGHT. CHECK ALIGNMENT OF ALL FOUR WHEELS. ADJUST CASTER, CAMBER, TOE-IN, AND THRUST ANGLE AS NEEDED ON ALL FOUR WHEELS. CENTER STEERING WHEEL..
    • WHEEL STUD – Remove & Replace – Front,One,One Side
    • Mount Tires
     
    JIMMY M. gave our service a 5 star review on 8/10/2022