FOUND: fuse number six in the instrument panel fuse block was missing. This fuse provides power for the left turn stop lamps. After this fuse was replaced, the rear turn signals function normally, however the left front turn signals remain on steady at all times even when the truck is off. There is apparently a short somewhere to the left front turn signals causing them to remain on. Circuit testing showed that the body control module is applying power at all times to the left front turn signal circuit. Disconnecting the body control module removes the power from this circuit. Recommend replace the body control module. Note that Aftermarket accessories that are tied into the body control module wiring may cause damage to the body control module.
additional labor to inspect LF light assembly, follow circuit all way back to BCM. SHORT TO POWER
Program body control module with latest Factory software.
GM ECU 2024 PROGRAMMING SOFTWARE UPDATE
GM LICENSE FEE
EVAN L. gave our service a 5 star review on 6/3/2024
FOUND:Code U1510 Lost communication with device on LIN Bus. This code indicates a loss of communication between the engine control module and the active Grille shutter control module. The bolts that have been installed for the aftermarket lights in the bumper are in the path of the active Grille shutter system. When the module attempts to move the shutters they will strike the bolts which will prevent movement and can cause the module to overheat. This is likely why there is no communication with the active Grille shutter module. The bumper fascia will have to be removed and the aftermarket lights will also have to be removed in order to access the active Grille shutter module for further testing. The aftermarket light assembly will have to be removed to prevent further damage, or refabricated to prevent the bolts from interfering with the active Grill shutter movement. Dope tested the circuits to the active Grill shutter module. Found that power and ground is available and at the proper levels. Also tested the Lynn bus circuit and found that it was active from the engine control module but messages were missing from the active Grill shutter module. Recommend replace the complete active Grill shutter assembly with the module.
Courtesy Vehicle Inspection: Includes vehicle inspection – report to be sent via text on any visual observations & any Scheduled MFG recommendations.
AIR FLOW SHUTTER ACTUATOR – Remove & Replace – Assembly (Complete) – [Includes: R&I Grille Assembly. Includes: R&I Bumper Assembly. Includes: R&I Headlamp Assemblies.] – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.]
AIR FLOW SHUTTER ACTUATOR – Remove & Replace – Assembly (Complete) – [Includes: R&I Grille Assembly. Includes: R&I Bumper Assembly. Includes: R&I Headlamp Assemblies.] – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.]
PATRICK R. gave our service a 5 star review on 2/19/2024
ROAD TEST VEHICLE. CHECK ALL SUSPENSION AND STEERING PARTS FOR WEAR. CHECK TIRE PRESSURE AND CONDITION. CHECK RIDING HEIGHT. CHECK ALIGNMENT OF ALL FOUR WHEELS. ADJUST CASTER, CAMBER, TOE-IN, AND THRUST ANGLE AS NEEDED ON ALL FOUR WHEELS. CENTER STEERING WHEEL..